Bosch MG1CS060 — supported tools

← ECU catalogue

Bosch MG1CS060 engine ECU with confirmed AutoTuner support via OBD. MCU variants: TC387. Reading and writing follow the protocol scope; match the ECU identification to a supported variant before use.

Last changed: 2026-10-31 · Card revision 3

Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.

Tool

Connection

Operations

Scope and notes

Alientech KESS3

OBD

Read (type unspecified)
Write

Bosch MG1CS060; Ford; KESS3 2.65

Confirmed functions for applications listed in KESS3 update 2.65. Activation for the corresponding vehicle category and mode is required; match the hardware variant in Alientech Suite.

AutoTuner

OBD

Read (type unspecified)
Write

MG1CS060; MCU variant TC387

Reading and writing. Scope covers AutoTuner-supported applications for the specified variant.

CMDFlash

OBD

Operations unspecified

MG1CS060; FORD F-250; 6.8 V8 298KW 405HP BOSCH MG1CS060 CAN; FORD F-250; 7.3 V8 316KW 430HP BOSCH MG1CS060 CAN; FORD F-350; 6.8 V8 298KW 405HP BOSCH MG1CS060 CAN; FORD F-350; 7.3 V8 316KW 430HP BOSCH MG1CS060 CAN

Mode compatibility confirmed by the official CMDFlash list. The corresponding protocol package is required; match functions and ECU variant in CMDFlash software.

Flex

OBD

Read (type unspecified)
Write
Checksum

Ford Bosch MG1CS060 TC387

Operations follow this Flex release. Writing and checksum processing in the map area according to the protocol.

Flex

OBD

Operations unspecified

MG1CS060; Ford E-350 (IV) 7.3L V8 Godzilla 16v 99N (2021–); Ford E-450 (IV) 7.3L V8 Godzilla 16v 99N (2021–); Ford F-250 Super Duty (V) 6.8L V8 16v 99A (2023–); Ford F-250 Super Duty (V) 7.3L V8 Godzilla 16v 99N (2023–); Ford F-350 Super Duty (V) 6.8L V8 16v 99A (2023–); Ford F-350 Super Duty (V) 7.3L V8 Godzilla 16v 99N (2023–); Ford F-450 Super Duty (V) 6.8L V8 16v 99A (2023–); Ford F-450 Super Duty (V) 7.3L V8 Godzilla 16v 99N (2023–); protocol 24430000; OBD

Confirmed compatibility for the specified protocol and applications. Requires one of these packages: FLS0.1M, FLS0.1S, FLS0.5M, FLS0.5S. Check this Flex protocol for detailed reading, writing and memory functions.

Pinout Bench

No Bench pinout has been added.

Pinout Boot

No Boot pinout has been added.

Update history

Revision 3 · 2026-10-31
Revision 2 · 2026-10-31
Revision 1 · 2026-10-31