Delphi CRD3P.G0 — supported tools

← ECU catalogue

Delphi CRD3P.G0 ECU reading and writing: AutoTuner: Boot — read and write; AutoTuner: Bench — read and write. Support applies to the MCU, vehicle and HW/SW variants specified for each programming tool. Check the OBD reading type, required unlocking and restrictions for the exact ECU.

Last changed: 2026-10-30 · Card revision 1

Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.

Tool

Connection

Operations

Scope and notes

AutoTuner

Bench

Read (type unspecified)
Write

Delphi CRD3P.G0; MCU TC1793; compatible HW/SW variants

Applies to MCU TC1793 and compatible vehicle and HW/SW variants in the AutoTuner list. Connection through the ECU connector without opening the housing.

AutoTuner

Boot

Read (type unspecified)
Write

Delphi CRD3P.G0; MCU TC1793; compatible HW/SW variants

Applies to MCU TC1793 and compatible vehicle and HW/SW variants in the AutoTuner list. Requires opening the ECU and PCB connection using AutoTuner instructions.

Pinout Bench

No Bench pinout has been added.

Pinout Boot

No Boot pinout has been added.

Update history

Revision 1 · 2026-10-30