Delphi DCM3.7AP — supported tools

← ECU catalogue

Delphi DCM3.7AP ECU reading and writing: AutoTuner: OBD — write. Support applies to the MCU, vehicle and HW/SW variants specified for each programming tool. Check the OBD reading type, required unlocking and restrictions for the exact ECU. IO Terminal Multi Tool with Opel/GM ECU activation supports FLASH reading and writing over CAN (OBD) for the MPC5566 variant; R5F72544 and R5F72513 variants also include DATAFLASH.

Last changed: 2026-10-30 · Card revision 2

Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.

Tool

Connection

Operations

Scope and notes

AutoTuner

OBD

Write

Delphi DCM3.7AP; MCU SH72513; compatible HW/SW variants

Applies to MCU SH72513 and compatible vehicle and HW/SW variants in the AutoTuner list. The page confirms OBD writing; real versus virtual reading is not distinguished.

IO Terminal

OBD

Read (type unspecified)
Write

Opel / GM; Multi Tool ECU activation; MPC5566

FLASH read/write over CAN (OBD).

IO Terminal

OBD

Read (type unspecified)
Write

Opel / GM; Multi Tool ECU activation; R5F72513

FLASH + DATAFLASH read/write over CAN (OBD).

IO Terminal

OBD

Read (type unspecified)
Write

Opel / GM; Multi Tool ECU activation; R5F72544

FLASH + DATAFLASH read/write over CAN (OBD).

Pinout Bench

No Bench pinout has been added.

Pinout Boot

No Boot pinout has been added.

Update history

Revision 2 · 2026-10-30
Revision 1 · 2026-10-30