Delphi DCM6.2AP — supported tools
← ECU catalogue
Delphi DCM6.2AP ECU reading and writing: AutoTuner: Boot — read and write. Support applies to the MCU, vehicle and HW/SW variants specified for each programming tool. Check the OBD reading type, required unlocking and restrictions for the exact ECU.
Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.
Tool
Connection
Operations
Scope and notes
AutoTuner
Boot
- Read (type unspecified)
- Write
Delphi DCM6.2AP; MCU MPC5674F; compatible HW/SW variants
Applies to MCU MPC5674F and compatible vehicle and HW/SW variants in the AutoTuner list. Requires opening the ECU and PCB connection using AutoTuner instructions.
Pinout Bench
No Bench pinout has been added.
Pinout Boot
No Boot pinout has been added.
Update history
- Revision 1 · 2026-10-30