Read and join the automotive discussion.

Mitsubishi MH8601F — supported tools

← ECU catalogue

Mitsubishi MH8601F engine control unit supported by PCMflash module 79 in Bench service mode through the ECU connector. FLASH reading and writing with checksum correction are confirmed. Match the connection to the exact control unit version.

Last changed: 2026-11-06 · Card revision 2

Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.

Tool
Connection
Operations
Scope and notes
PCMflash
Bench
  • Read (type unspecified)
  • Write
  • Checksum

Module 79: Mitsubishi MH8601F, FLASH memory, CAN service mode through the ECU connector.

Requires module 79 license and direct ECU connector connection. The manual distinguishes two MH8601F connection versions. EEPROM access and cloning are not claimed.

Pinout Bench

Mitsubishi MH8601F — PCMflash 79 Bench, connection versions 1 and 2Open full-size image ↗

Mitsubishi MH8601F — PCMflash 79 Bench, connection versions 1 and 2

Tool: PCMflash

Original PCMflash module 79 wiring diagram for the Mitsubishi MH8601F ECU in Mitsubishi vehicles, page 8 of manual v1.13; drawing v2 dated 2023-09-17. The two connection versions use different CAN pins in connector B — select only the variant matching the exact ECU and programmer instructions. Bench service mode via the ECU connector; do not apply this diagram to MH8610F, MH8611F or other programmers.

Pinout Boot

No Boot pinout has been added.

Update history
  • Revision 2 · 2026-11-06
  • Revision 1 · 2026-11-06