Siemens SIRIUS D3 — supported tools
Siemens SIRIUS D3 — control unit with confirmed compatibility with: ChipLoader, MDFlasher. Application scope, modes, operations and requirements are specified separately for each programmer. Match the protocol to the exact controller variant.
Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.
- Write
Sirius/SIM2K-34VR module; SIRIUS D3; Chevrolet/Daewoo.
Writes 32 KB calibrations.
- Read (type unspecified)
- Write
- Checksum
License 086; Chevrolet; diagnostic calibration programming; SIRIUS D3 (SIRIUS D3).
Program and calibration reading; calibration-only writing with checksum. The manufacturer requires preparation of the immobilizer system and diagnostic line during programming.
- Read (type unspecified)
- Write
- Cloning
License 086; Chevrolet; full Flash image and emulated EEPROM; SIRIUS D3 (SIRIUS D3).
Full Flash and emulated EEPROM read/write; mode intended for cloning. D32/D42/42R/D52: 512 KB; 4R/D3: 256 KB.
Pinout Bench
No Bench pinout has been added.
Pinout Boot
No Boot pinout has been added.
Update history
- Revision 1 · 2026-11-08