Read and join the automotive discussion.

Temic DKG436 GEN2 — supported tools

← ECU catalogue

Temic DKG436 Gen2 BMW transmission controller with an TC1784 microcontroller. Bench reading and writing confirmed for AutoTuner and PCMflash module 58.

Last changed: 2026-11-09 · Card revision 3

Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.

Tool
Connection
Operations
Scope and notes
AutoTuner
Bench
  • Read (type unspecified)
  • Write

Temic DKG436 Gen2; BMW; MCU TC1784

Reading and writing through the controller connector. Match the correct TCU generation.

PCMflash
Bench
  • Read (type unspecified)
  • Write

Module 58; DKG436 Gen2 BMW; FLASH and EEPROM

Service mode; direct connection through the TCU connector.

Xhorse MULTI-PROGHistorical information
Bench
  • Read (type unspecified)
  • Write

BMW: DKG436_Gen2

Read and write confirmed in the official historical Database V4 list. Limited to identifiers and variants stated in the scope; select the exact item in the current device database. This list does not establish checksum correction or cloning here.

Pinout Bench

Temic DKG436 Gen2 BMW — PCMflash 58 BenchOpen full-size image ↗

Temic DKG436 Gen2 BMW — PCMflash 58 Bench

Tool: PCMflash

Temic DKG436 Gen2 BMW, TCU variant shown in the image. Connector wiring for PCMflash module 58 Bench service mode. Applies to generation 2; not for DKG436 Gen1.

Pinout Boot

No Boot pinout has been added.

Update history
  • Revision 3 · 2026-11-09
  • Revision 2 · 2026-11-06
  • Revision 1 · 2026-11-06