ZF AMT-JHQ — supported tools
ZF AMT/JHQ automated transmission controller for VAZ/Lada and Renault. PCMflash module 96 accesses memory through the TCU connector without opening. CombiLoader supports the VAZ variant through the diagnostic connector.
Compatibility depends on ECU HW/SW, protocol and active licence. A tool missing from this list does not imply lack of support.
- Read (type unspecified)
- Write
- Checksum
AMT VAZ only; CombiLoader 2.16 or newer.
Flash read/write through the diagnostic connector. Automatic calibration checksum correction on writing. Requires a J2534 interface.
- Read (type unspecified)
- Write
ZF AMT/JHQ; MCU/memory: TC1782N; RENAULT, VAZ.
Read: internal Flash, internal EEPROM. Write: internal Flash, internal EEPROM. Listed adapters: MP001/P003/P003+/P004. TCM V31.11; match the exact variant on the device.
- Read (type unspecified)
- Write
ZF AMT/JHQ; MCU/memory: TC1782N; RENAULT, VAZ.
Read: internal Flash, internal EEPROM. Write: internal Flash, internal EEPROM. Listed adapters: MP001/P003/P003+/P004. TCM V31.11; match the exact variant on the device. Requires ECU MASTER A package.
- Read (type unspecified)
- Write
- Checksum
VAZ AMT / Renault JHQ; module 96.
Flash and EEPROM read/write. Flash checksum verification and correction. Connector access without opening; module 96 diagram, p.8.
Pinout Bench
Open full-size image ↗AMT/JHQ — VAZ/Renault — PCMflash 96 Bench
Original PCMflash module 96 v1.00 diagram, page 8. ZF AMT/JHQ VAZ/Renault, T1/T2 connectors. +12 V: T2/A2 and T2/M1; GND: T2/M4; CAN-L: T2/J2; CAN-H: T2/J1. Applies only to the illustrated connector variant.
Pinout Boot
No Boot pinout has been added.
Update history
- Revision 4 · 2026-11-07
- Revision 3 · 2026-11-07
- Revision 2 · 2026-11-07
- Revision 1 · 2026-11-07